The Central Box 200 is a switchboard designed for the complete management of servos in a model with an
emphasis on safety. The Central Box has a unique design that provides overload protection at each servo
output. The Central Box can manage up to two batteries and fully supports the Jeti EX telemetry system.
Up to two receivers with serial (PPM, EX Bus) output as well as two power batteries can be connected at
the same time to the Central Box for complete Power & RF signal redundancy.
With Jeti Duplex 2.4GHz DC/DS transmitters, the full potential of the Central Box can be used, such as
an easy way to wirelessly configure the Servo Outputs, EX Telemetry, Fail-Safe Setting or Fast Servo
(1) Jeti Central Box 200
(2) Jeti Duplex EX R3/RSW 2.4GHz Receiver
(1) Magnetic Switch
(1) Magnetic Key
The JetiBox monitor/programmer can be used for parameter setting and retrieving data. After connecting to
the Central Box (Ext1), a startup screen appears that contains identification of the device in the first
line of the JetiBox display.
The power batteries are connected to the Central Box using MPX connectors. The Central Box allows two
batteries to be connected. During use, the power is actually supplied from the battery with the higher
voltage. If the voltage is the same, the power can be used from both batteries at the same time. When the
voltage of the batteries is different, the power is not shared and each pack is isolated from the other.
This allows you to use batteries of different capacity, number of cells and chemistry type. If the power
for the Central Box is provided only from one battery, it can be connected via battery (BATT1) Input.
Magnetic Switch (Included)
The magnetic switch is used to turn the Central Box ON/OFF and is connected to a separate slot labeled
"Switch". To turn on the Central Box using the magnetic switch it is necessary to hold the supplied
magnet (key) to the target so that the key and the target on the magnetic switch are properly oriented.
Wireless Switch R3/RSW (Optional)
State-of-the-art device that sets Jeti as a leading designer and manufacturer of radio control systems.
Wireless power switch is fully integrated into the 2.4GHz radio system. For first time your receiver can
be turned ON/OFF with simple flipping of the switch wirelessly from the Jeti DC/DS transmitters.
Central Box 200 installations done by Jeti USA Team pilot Joe Smith & our friend C.Brent.
- Control Management with Configurable Servo Output
- Power Distribution with Two Independent Inputs
- Firmware Updatable via Jeti USB Adapter
- Jeti Duplex EX Bus or PPM Compatible
- Wirelessly Programmable Using DC/DS Tx Device Explorer
- Independent Receiver Signal Inputs (SAT1, SAT2)
- Up to 15x Servo Outputs with Overload Protection
- Up to 3x Telemetry Sensors Inputs (Ext1, Ext/14, Ext/15)
- Input for Included Magnetic or Optional Wireless Switch
- Input Voltage: 3.5-15V
- Output Current: 2x 10A Continues/90A Peak
- Dimensions/Weight: 62mm x 38mm x 16mm/30g
More information (links):
* Instruction Manual (.pdf)
* Menu Diagram (.pdf)
Switches ON/OFF of the Fail-Safe function. If the Fail-Safe function is deactivated, there is no signal
generated in any Central Box outputs at the signal loss. If you activate the Fail Safe function, you can
also select how the Central Box responds at signal loss for each of the individual outputs.
Servo No. - Assigning outputs of the transmitter to the Central Box outputs.
Group - Assigning specific output to the group of output impulses that will be generated from the receiver
in the same time.
Temperature - Temperature of the Central Box
Shorted Outputs No. - Number of Overloaded Outputs
Voltage - Voltage of Individual Outputs of the Central Box
Current - Current Drawn from the Battery
Capacity - Capacity Taken from the Batteries